Daily maintenance of generators can extend service life

The long-term use of the generator set or prompts that it needs maintenance after long use. In order to maintain the performance of the generator set and keep the generator in good condition. The following is an example of some problems a certain customer's generator has not been regularly maintained due to long-term use but has not been regularly maintained.
There are mainly these steps for maintaining the generator. Before starting the generator, the engine oil should be filled through the gas refueling port. When filling, the engine should be placed in a horizontal position and pay attention to the changes in the generator oil level. Generators require the use of multi-stage viscosity engine oil because multi-stage viscosity engine oil has a wide operating temperature range and consumes about 30% lower than single-stage viscosity engine oil. After adding oil, you have to wait a while before checking the oil level on the generator oil ruler. That is, the oil level you see after the oil has flowed into the oil pan is the correct value. Each oil filter should be filled with cleaning oil before it can be installed on the engine. The performance level of engine oil represents the level of engine oil additives. Only by choosing sufficient grades of engine oil for maintenance can the generator be guaranteed to be reliable protection during the entire oil change cycle.
Secondly, when maintaining the generator, you should pay attention to filling in coolant before starting. When filling, open the air vent valve of the upper cooling system of the engine and slowly add the coolant from the water supply port of the heat dissipation water tank to the engine until there are no bubbles and then discharge from the air vent valve. The coolant should be filled below the neck of the radiating water tank and should not be too full.
Then, the entire generator set is cleaned. Due to the long-term placement of the generator, dust is easily accumulated and the diesel residue affects the normal operation of the generator. Therefore, we should regularly clean their styles, water grids, etc., and regularly turn on and check to ensure the normal operation of the generator.