Will a diesel generator set become 'bad' if it is not used for a long time?

Will the diesel generator be damaged if it is left idle for a long time? This statement has puzzled many users. Haixing Power will tell you in detail why dieselGenerator setThere will be a 'stop' phenomenon.

Reduced filtration capacity of the filter

The filter plays a role in filtering diesel, engine oil or water to prevent impurities from entering the body. Oil dirt and impurities are also inevitable in diesel, so the filter plays an important role during the operation of the unit. But at the same time, these oil stains or impurities will also be Deposition on the filter wall will reduce the filtering capacity of the filter. If there is too much deposition, the oil circuit will not be smooth. In this way, when the oil machine is running under load, it will go into shock due to the inability to supply oil (like a person lacking oxygen). Therefore, a normal generator set will During use, it is recommended that: 1. Every 500 units of commonly used units Replace the third filter every hour; 2. Replace the third filter of the backup unit every two years.

Poor water circulation in cooling system water pipelines

The water pump, water tank and water pipeline have not been cleaned for a long time, resulting in poor water circulation and reduced cooling effect. Whether the water pipe joints are in good condition, whether there are leaks in the water tank and water channels, etc. If the cooling system fails, the consequences are: 1. Cooling effect Otherwise, the water temperature in the unit will be too high and the unit will shut down; 2. The water tank will leak and the water level in the water tank will drop, and the unit will not work properly (in order to prevent the water pipes from freezing when using the generator in winter, it is recommended to install water heating in the cooling system device).

Therefore, before a generator set that has been idle for a period of time is put into use again, a complete performance check must be performed to confirm the status of the equipment.