Cummins diesel generator set operating procedures

After purchasing a Cummins diesel generator set, customers should pay attention to safe use and strictly abide by the operating procedures to ensure the normal operation of the diesel generator set. So, CumminsDiesel generator setWhat are the specific operating procedures? Haixing is here to introduce it to you.

Preparations before starting up
1. Check whether the oil level in the crankcase of the diesel engine is normal, and check whether the cooling water tank is cooled (enough cooling water and oil should be added).
2. Open the diesel valve to clear the fuel pipeline.
3. Manually turn the machine to check whether the moving parts are stuck.
4. Whether the starting motor current meets the starting requirements.
5. Check whether the water pump, oil pump and fan conveyor belt are normal.
6. Start the diesel generator after confirming the above inspections.

Two starts
1. Turn on the starting power switch and start.
2. After starting the diesel generator, run it without load for 5 minutes. Distribute power after confirming that the cooling water temperature and engine oil temperature are normal.
3. Close the generator output switch, disconnect the mains power, close the power generation and distribution knife switch on the distribution cabinet, and distribute power according to the power consumption requirements.

3. On-the-fly management
1. When the generator is running, a dedicated person must be on duty, and pay attention to the oil pressure, water temperature, etc. during duty.
2. During duty, pay attention to whether the generator has any peculiar smell, noise, smell, or abnormal response. Shut down the generator for inspection and report to the equipment department for processing.

Four shutdowns
1. Remove the load, close the mains generator gate, open the generator output end knife gate, wait for the generator to run without load for 5-10 minutes, and stop when the oil and water temperature drops to 40-55 degrees.
2. To keep the emergency diesel generator clean and tidy, clean the fuselage after shutdown.

5. Repair and maintenance
1. Diesel engine maintenance generally requires maintenance after 2,500 to 3,000 hours of use. Intermediate repair content: check the gas part, connecting rod shaft, replace parts, etc.
2. This machine uses Cummins engine oil. The engine oil is generally used continuously for 250-300 hours before the oil and oil filter are replaced.
3. Diesel filter, water filter depends on usage.

The above are the operating procedures for Cummins diesel generator sets that Haixing has listed for everyone. We hope that relevant staff will refer to them and abide by them during specific operations. This will not only extend the service life of Cummins diesel generator sets, save corporate costs, but also ensure safe production and expand Enterprise benefits.